# 2007 February 6 # # The author disclaims copyright to this source code. # #************************************************************************* # This file implements regression tests for SQLite library. This # tests creating fts3 tables in an attached database. # # $Id: fts3aj.test,v 1.1 2007/08/20 17:38:42 shess Exp $ # set testdir [file dirname $argv0] source $testdir/tester.tcl # If SQLITE_ENABLE_FTS3 is defined, omit this file. ifcapable !fts3 { finish_test return } # Clean up anything left over from a previous pass. forcedelete test2.db forcedelete test2.db-journal sqlite3 db2 test2.db db eval { CREATE VIRTUAL TABLE t3 USING fts3(content); INSERT INTO t3 (rowid, content) VALUES(1, "hello world"); } db2 eval { CREATE VIRTUAL TABLE t1 USING fts3(content); INSERT INTO t1 (rowid, content) VALUES(1, "hello world"); INSERT INTO t1 (rowid, content) VALUES(2, "hello there"); INSERT INTO t1 (rowid, content) VALUES(3, "cruel world"); } # This has always worked because the t1_* tables used by fts3 will be # the defaults. do_test fts3aj-1.1 { execsql { ATTACH DATABASE 'test2.db' AS two; SELECT rowid FROM t1 WHERE t1 MATCH 'hello'; DETACH DATABASE two; } } {1 2} # Make certain we're detached if there was an error. catch {db eval {DETACH DATABASE two}} # In older code, this appears to work fine, but the t2_* tables used # by fts3 will be created in database 'main' instead of database # 'two'. It appears to work fine because the tables end up being the # defaults, but obviously is badly broken if you hope to use things # other than in the exact same ATTACH setup. do_test fts3aj-1.2 { execsql { ATTACH DATABASE 'test2.db' AS two; CREATE VIRTUAL TABLE two.t2 USING fts3(content); INSERT INTO t2 (rowid, content) VALUES(1, "hello world"); INSERT INTO t2 (rowid, content) VALUES(2, "hello there"); INSERT INTO t2 (rowid, content) VALUES(3, "cruel world"); SELECT rowid FROM t2 WHERE t2 MATCH 'hello'; DETACH DATABASE two; } } {1 2} catch {db eval {DETACH DATABASE two}} # In older code, this broke because the fts3 code attempted to create # t3_* tables in database 'main', but they already existed. Normally # this wouldn't happen without t3 itself existing, in which case the # fts3 code would never be called in the first place. do_test fts3aj-1.3 { execsql { ATTACH DATABASE 'test2.db' AS two; CREATE VIRTUAL TABLE two.t3 USING fts3(content); INSERT INTO two.t3 (rowid, content) VALUES(2, "hello there"); INSERT INTO two.t3 (rowid, content) VALUES(3, "cruel world"); SELECT rowid FROM two.t3 WHERE t3 MATCH 'hello'; DETACH DATABASE two; } db2 } {2} catch {db eval {DETACH DATABASE two}} catch {db2 close} forcedelete test2.db finish_test